The only UV-DYE that penetrates the lens surface. During the short (6 to 10 min.) heating process, the pores of the lens open up and the chemical is permanently encapsulated in the lens surface. A treated lens will absorb 100 % UV from 260 nm to 400 nm The absorption will not weaken in time but increase. Insertion into lens tint neutralizer will not affect absorption. It will remove the yellow tinge only.
Same procedures as with regular lens tint. Add regular tap water to concentrate to make one quart total. Heat solution to 94.0C or 205F. IT IS EXTREMELY IMPORTANT THAT THE TEMPERATURE IN THE DYE POT IS THE ONE SPECIFIED. Insert cleaned lenses only when temperature is reached. As UV- 400 SUPER FAST is a deep penetrating solution, best results are obtained by leaving lens in the solution between 6 and 10 minutes. Remove lens from solution and let lens cool off before washing residue off under hot water. Any residue can also be cleaned with acetone or alcohol. Check absorbtion or transmission with an UV-METER. If transmission is over 4 % redo the lens in a fresh solution. Evaporated liquid should be replaced with regular water so those inserted lenses are completely covered by the UV400 SUPER FAST solution. Replace or check the efficiency of the solution after 7 reheat and cooling cycles (7days if heated every day) or after 7 days of continuous heating.
Do not Insert lenses into solution as it is heating up and has a not attained the full temperature. Do not leave lenses in the solution as it is cooling down. UV-SUPER FAST at temperatures below 94C or 205F might damage lens surfaces by blistering or the creation of small holes. Should through one of these reasons a lens surface be blistered or has holes, it can be corrected by placing the lens into hot neutralizer for 11/2 to 2 hours. Do not re-insert lenses into UV-400 SUPER FAST, the treatment is still there and can not be removed. The yellowish tinge will be gone but the protection will be fully there. Available now also in a CRYSTAL CLEAR versin that has no yellowish tinge Material Safety Data
Sheet
E-mail us! e-mail: oms_optical@yahoo.com |
|||||||||||||||||
Chemical
Nano Technology
How to Treat a Lens
Chemical
Nano Technology 